Bracket Arm
Category
-
Suspension and Steering
- Ball Joints
- Bracket Arm
- Center Link
- Coil Spring
- Constant Velocity Joints
- Control Arm Bush
- Control Arms
- Drag Link
- Drive Shaft
- Flexible Coupling
- Idler Arm
- King Pin Set
- Pitman Arm
- Rack End
- Shock Absorbers
- Side Rod Assembly
- Sports Coil Spring
- Stabilizer Link Rod
- Steering Rack Assembly
- Tie Rod End
- Universal Joints
- View All
- Cooling System
- Fuel and Ignition Systems
- Powertrain and Transmission
- Engine Components
- Braking System
- Lubricants and Grease
- Hardware and Paints
-
Electrical and Auxiliary Components
- Accelerator Cable
- Air Con Fan Motor
- Alternator Hose
- Bonnet Cable
- Brake Light Switch
- Choke Cable
- Clutch Control Cable
- Door Lock Cable
- Electrical Sensors
- Engine Stop Cable
- Fuel Lid Cable
- Gear Lever Cable
- Hand Brake Cable
- Headlight Bulb
- Oil Pressure Sender
- Power Take-Off (PTO) Cable
- Sliding Door Cable
- Speedometer Cable
- Stop Light Switch
- Tail Light Bulb
- Throttle Cable
- Trunk Opener Cable
- Wiper Blade
- View All
- View All
Brand
Bracket arm in suspension parts:
-
Control Arm Mounting:
- Purpose: Bracket arms may be involved in the mounting and support of control arms. Control arms are crucial components in the suspension system that connect the wheel hub to the vehicle's chassis.
-
Stabilizer Bar Attachment:
- Purpose: Some suspension systems use bracket arms to attach and support the stabilizer bar (also known as sway bar or anti-roll bar). The stabilizer bar contributes to vehicle stability during cornering.
-
Spring and Strut Mounting:
- Purpose: Bracket arms might be involved in securing and supporting coil springs or struts within the suspension system. They play a role in maintaining proper alignment and positioning of these components.
-
Linkage Support:
- Purpose: Bracket arms can be used to support various linkages within the suspension, such as those connected to the sway bar or other components contributing to the suspension geometry.
-
Shock Absorber Mounting:
- Purpose: In certain suspension designs, bracket arms could be responsible for securing and supporting shock absorbers or dampers. These components are critical for controlling vehicle motion and ensuring a comfortable ride.
-
Subframe Attachment:
- Purpose: Some suspension systems incorporate subframes, and bracket arms may serve as attachment points for these subframes. Subframes provide additional structural support and may house various suspension components.
-
Alignment Adjustments:
- Purpose: Bracket arms with adjustable features may facilitate alignment adjustments in the suspension system. This allows for fine-tuning of alignment angles for optimal handling and tire wear.
-
Crossmember Support:
- Purpose: Bracket arms may be involved in supporting the crossmember, a structural component that spans the width of the vehicle and provides support for various suspension and engine components.
-
Attachment for Suspension Bushings:
- Purpose: Bracket arms may house or support suspension bushings. These bushings contribute to the flexibility of the suspension system while maintaining stability and control.
-
Chassis Reinforcement:
- Purpose: In some cases, bracket arms may contribute to reinforcing the vehicle's chassis, especially in areas where suspension components are attached.
It's important to note that the specific purpose of a bracket arm can vary based on its location within the suspension system and the overall design of the vehicle. If you have a particular suspension component or system in mind, providing more details would enable a more accurate and tailored explanation.
